Q26. What is the correct order of steps taken during the BIOS/UEFI Recovery process?

Q27. How can a technician know whether IDRAC9 System Lockdown mode is enabled?

Q28. Which rear disk drive option is available in a Dell EMC PowerEdge R740xd server?

Q29. What is a key feature introduced in OpenManage Mobile v2.0?

Q30. Starting from which Dell EMC PowerEdge server hardware generation is the Micro SD card in the IDSDM/vFlash module supported?

Q31. You must configure a BOSS card with 2 x 120GB drives for a Dell EMC PowerEdge server. What is the only supported mode?

Q32. What must be done before upgrading OMSA from the 32-bit to the 64-bit version?

Q33. Starting from which Dell EMC PowerEdge server hardware generation is the Micro SD card in the IDSDM/vFlash module supported?

Q34. A technician is sent on-site to troubleshoot a server that produced an error message during the most recent POST, but then completed the POST and booted to the operating system. The user cannot remember the specific error and no entry was made in the error log relating to this error.
How can the technician find out what the error message was?

Q35. A Dell EMC PowerEdge server has been updated with an LCC and iDRAC DUP to the latest firmware when performing a firmware rollback?

Q36. What is a requirement to operate GPUs in a Dell EMC PowerEdge R740 server?

Q37. A technician installs eight servers into a fully operational rack with top of rack switch Each server has a quad 1Gb NIC and redundant power supplies The company uses iDRAC in shared LOM mode with LOM1 as the selected NIC What should the technician do to verify iDRAC connectivity on each server?

Q38. Which processor configuration is used by the Dell EMC PowerEdge R740 server?

Q39. A technician is creating a virtual disk in the iDRAC (2x 4 TB NL-SAS in RAID 1) to install Windows 2016 They manually boot to the OS installation media without using the Lifecycle Controller OS Deployment wizard Only the first 2048 GB on the virtual disk can be partitioned How should the technician obtain access to the remaining 2 TB (approximately) of storage?

Q40. What is the Open Compute Project (OCP) card used for in a Dell EMC PowerEdge server?

Q41. A company that has very specific firmware requirements has acquired Dell EMC PowerEdge servers Any replaced parts of the type must match the original parts identically. The procedure must be as simple as possible with minimal risk.
What action should a technician take to help accomplish this goal?

Q42. What is a requirement to operate GPUs in a Dell EMC PowerEdge R740 server?

Q43. Match each RAID level to its characteristic.

Q44. What is the Open Compute Project (OCP) card used for in a Dell EMC PowerEdge server?

Q45. A technician needs to update the IDRAC license on a Dell EMC PowerEdge R740 server from Express to Enterprise. The server has the following components:
* 2x CPUs
* 384 GB RAM
* 6x 1 TB drives
* 1x PSU
The server is connected to active AC, but it is powered down, and it needs to stay powered down No errors are presently displayed How can the technician upgrade the license?