NEW QUESTION 39
A technician has replaced a network daughter card (NDC) with a different, supported NDC.
Using the Lifecycle Controller, what can they do to verify that the new NDC is present?

NEW QUESTION 40
A technician is troubleshooting a server with the following components:
Two CPUs
Memory installed in sockets A1, A2, A3, A4, A5, A6, B1, B2, B3, B4, B5 and B6 Expansion cards installed in all expansion slots
6x 1 TB drives configured as a RAID 6 virtual disk
The server has the following symptoms:
CPU2 has failed
Memory in slots B1, B2, B3, B4, B5 and B6 is not accessible
Some of the expansion cards have gone offline.
What should the technician do to resolve this issue?

NEW QUESTION 41
A technician needs to use the iDRAC GUI to roll back a diagnostics firmware revision on a server that was updated four weeks previously. However, the replaced version cannot be found in the Firmware Rollback section on the iDRAC GUI.
What could be the issue?

NEW QUESTION 42
Refer to the exhibit.

A technician it installing an OS to a server. The OS array is 2.8TBs. The OS install is unable to start.
What should the technician do to install the OS?

NEW QUESTION 43
A technician installs eight servers into a fully operational rack with top of rack switch Each server has a quad 1Gb NIC and redundant power supplies. The company uses iDRAC in shared LOM mode with LOM1 as the selected NIC.
What should the technician do to verify iDRAC connectivity on each server?

NEW QUESTION 44
A technician plugs in a server that has dual power supply units. After powering on the system, they notice that the power supply status indicators blink green then turn off.
What troubleshooting steps should the technician take to resolve this issue?

NEW QUESTION 45
A technician working with a Dell EMC PowerEdge 14G server observes the PCIe indicator turn solid amber.
What should they do to take corrective action upon checking the System Event log?

NEW QUESTION 46
A technician resets the iDRAC but when they attempt to log back in to the iDRAC is offline.
Why is the iDRAC offline?

NEW QUESTION 47
When does a customer require the Service Tag of the Dell EMC PowerEdge server?

NEW QUESTION 48
A technician is ready to deploy a server. If a critical part such as the system board fails, they must be able to replace the system board, reconfigure components, and update the firmware revisions in the fastest possible time.
How should the technician meet this requirement?

NEW QUESTION 49
A technician is configuring a PowerEdge R640 that has two PSUs. The rack in which it is being installed has two power distribution units (PDUs). No high power such as GPUs are required. The user wants as must redundancy protection as possible.
What is the best way to configure the PSUs?

NEW QUESTION 50
A remote system administrator must troubleshoot a server fault.
Which step provides the information that they need?

NEW QUESTION 51
A technician needs to update the iDRAC license on a PowerEdge R540 from Basic to Enterprise.
The server cannot be taken offline but the technician needs to have the additional features of the Enterprise license active as soon as possible.
How can the technician upgrade the license?

NEW QUESTION 52
A technician is troubleshooting a rackmount server that is NOT displaying video.
The technician has the following information:
– Known good monitor does NOT work when plugged into the front VGA port
– The power button is on
– iDRAC has an enterprise license
– The “i” button is blue
– NO operating system is installed on the server
Which two steps should the technician take to troubleshoot the issue? (Choose two.)

NEW QUESTION 53
What is the difference between iDRAC Direct 2.0 in 14G and iDRAC Direct in 13G Dell EMC PowerEdge servers?

NEW QUESTION 54
A technician needs to install several firmware updates on a server. The server cannot be rebooted until the customer performs a routine reboot.
What method should the technician use?

NEW QUESTION 55
A technician needs to install a server with a PERC RAID controller and 24, 2.5″ SAS SED drives.
The installation requires the following items to be created:
– Three equal-sized virtual disks
– Encrypted virtual disks
– A global hot spare
In addition to selecting the physical drive to be the hot spare disk, what tasks should the technician perform to set up the RAID controller?

NEW QUESTION 56
A technician needs to repurpose a server. The server has dual processors with 18 cores each. The OS only sees 24 threads in total.
Which setting should the technician change in Processor Settings in the System BIOS?

NEW QUESTION 57
What operation should a technician perform to ensure configuration recovery if a server must be physically replaced?

NEW QUESTION 58
Which iDRAC menu includes the detailed log files required to troubleshoot a hardware issue on a Dell EMC PowerEdge server?

NEW QUESTION 59
What is a requirement to operate GPUs in a Dell EMC PowerEdge R740 server?

NEW QUESTION 60
An existing server is transferred to a new location. The technician is directed to change the information displayed on the LCD located on the front bezel to show the ambient temperature.
What is a consideration for the technician?

NEW QUESTION 61
A technician is using the iDRAC web GUI to upload a firmware that requires a reboot. They select the update and choose ‘Apply Update and Reboot Now’.
How could the technician determine the status of the firmware update?