QUESTION 80
To provide different network services for different users on the AP, which of the following can be configured?

QUESTION 81
Which of the following refers to network communication? ()*

QUESTION 82
The Layer 2 networking of WLAN means that the STA uses the AC as its gateway.

QUESTION 83
Which of the following features does the OSPF protocol have? ()*

QUESTION 84
Which of the following statements about VLANIF interfaces are correct?

QUESTION 85
The network administrator hopes that the data packets sent from host A. to host B. pass through the G0/0/3 interface between routers, and the data packets sent from host B. to host A. pass through G0/ between routers. 0/4 interface, which of the following commands can achieve this requirement? ()

QUESTION 86
The routing table is shown in the figure. Which of the following statements is correct? () (Multiple Choice Questions)

QUESTION 87
Which of the following statements about Prefix Segment is wrong? ()

QUESTION 88
On the VRP platform, the default protocol priority of routes in the direct route, static route, RIP.OSPF area, from high to low, is ()

QUESTION 89
When planning a campus network, which of the following methods can be used to divide service VLANs? ()

QUESTION 90
ip route-static.10.0.2.2255.255.255.25510.0.12.2 preference20, the correct statement about this command is ()

QUESTION 91
In the VRP interface, use the command startup saved-configuration backup.cfg to configure the startup.cfg file for the next startup.

QUESTION 92
Which of the following statements about the edge port in the RSTP protocol is correct? ()

QUESTION 93
What command can be typed in the system view to switch to the user view? ()

QUESTION 94
AC. Use CAPWAP control tunnel to transmit management messages to FIT AP. ()

QUESTION 95
When using FTP for file transfer, how many TCP connections will be established? ()

QUESTION 96
Which version of the SNMP protocol below supports encryption features?

QUESTION 97
A network engineer prompts the following message when entering the command line: Error:
‘ position. Which of the prompt information is correct? () UnrecognizeD.commanD.founD.at ‘