NEW QUESTION 57
A technician is troubleshooting a user’s laptop that is unable to connect to a corporate server. The technician thinks the issue pertains to routing. Which of the following commands should the technician use to identify the issue?

NEW QUESTION 58
SIMULATION
Users are unable to access files on their department share located on flle_server 2. The network administrator has been tasked with validating routing between networks hosting workstation A and file server 2.
INSTRUCTIONS
Click on each router to review output, identity any Issues, and configure the appropriate solution If at any time you would like to bring back the initial state of trie simulation, please click the reset All button;

NEW QUESTION 59
Which of the following are environmental factors that should be considered when installing equipment in a building? (Select two).

NEW QUESTION 60
An organization has a security requirement that all network connections can be traced back to a user. A network administrator needs to identify a solution to implement on the wireless network. Which of the following is the best solution?

NEW QUESTION 61
A network technician replaced an access layer switch and needs to reconfigure it to allow the connected devices to connect to the correct networks.
INSTRUCTIONS
Click on the appropriate port(s) on Switch 1 and Switch 3 to verify or reconfigure the correct settings:
Ensure each device accesses only its
correctly associated network.
Disable all unused switchports.
. Require fault-tolerant connections
between the switches.
. Only make necessary changes to
complete the above requirements.

NEW QUESTION 62
Which of the following steps of the troubleshooting methodology should a technician take to confirm a theory?

NEW QUESTION 63
After installing a series of Cat 8 keystones, a data center architect notices higher than normal interference during tests. Which of the following steps should the architect take to troubleshoot the issue?

NEW QUESTION 64
Which of the following steps in the troubleshooting methodology includes checking logs for recent changes?

NEW QUESTION 65
A network engineer is designing a secure communication link between two sites. The entire data stream needs to remain confidential. Which of the following will achieve this goal?

NEW QUESTION 66
A company is implementing a wireless solution in a high-density environment. Which of the following 802.11 standards is used when a company is concerned about device saturation and converage?

NEW QUESTION 67
Which of the following panels would be best to facilitate a central termination point for all network cables on the floor of a company building?

NEW QUESTION 68
Which of the following is the most secure way to provide site-to-site connectivity?

NEW QUESTION 69
A network administrator configured a router interface as 10.0.0.95 255.255.255.240. The administrator discovers that the router is not routing packets to a web server with IP 10.0.0.81/28. Which of the following is the best explanation?

NEW QUESTION 70
A network administrator is implementing security zones for each department. Which of the following should the administrator use to accomplish this task?

NEW QUESTION 71
A network administrator needs to connect two routers in a point-to-point configuration and conserve IP space.
Which of the following subnets should the administrator use?

NEW QUESTION 72
Which of the following IP transmission types encrypts all of the transmitted data?

NEW QUESTION 73
An administrator is setting up an SNMP server for use in the enterprise network and needs to create device IDs within a MIB. Which of the following describes the function of a MIB?

NEW QUESTION 74
SIMULATION
You have been tasked with setting up a wireless network in an office. The network will consist of 3 Access Points and a single switch. The network must meet the following parameters:
The SSIDs need to be configured as CorpNet with a key of S3cr3t!
The wireless signals should not interfere with each other
The subnet the Access Points and switch are on should only support 30 devices maximum The Access Points should be configured to only support TKIP clients at a maximum speed INSTRUCTONS Click on the wireless devices and review their information and adjust the settings of the access points to meet the given requirements.
If at any time you would like to bring back the initial state of the simulation, please click the Reset All button.

NEW QUESTION 75
A network engineer wants to implement a new IDS between the switch and a router connected to the LAN. The engineer does not want to introduce any latency by placing the IDS in line with the gateway. The engineer does want to ensure that the IDS sees all packets without any loss. Which of the following is the best way for the engineer to implement the IDS?

NEW QUESTION 76
A network administrator wants to implement security zones in the corporate network to control access to only individuals inside of the corporation. Which of the following security zones is the best solution?