Q32. Which ADVPN configuration must be configured using a script on fortiManager, when using VPN Manager to manage fortiGate VPN tunnels?

Q33. Refer to the exhibit, which shows an error in system fortiguard configuration.

What is the reason you cannot set the protocol to udp in config system fortiguard?

Q34. Exhibit.

Refer to the exhibit, which contains a partial VPN configuration.
What can you conclude from this configuration1?

Q35. Exhibit.

Refer to the exhibit, which contains the partial ADVPN configuration of a spoke.
Which two parameters must you configure on the corresponding single hub? (Choose two.)

Q36. An administrator has configured two fortiGate devices for an HA cluster. While testing HA failover, the administrator notices that some of the switches in the network continue to send traffic to the former primary device What can the administrator do to fix this problem?

Q37. Exhibit.

Refer to the exhibit, which contains a CLI script configuration on fortiManager. An administrator configured the CLI script on FortiManager rut the script tailed to apply any changes to the managed device after being executed.
What are two reasons why the script did not make any changes to the managed device? (Choose two)

Q38. Refer to the exhibit, which shows config system central-management information.

Which setting must you configure for the web filtering feature to function?

Q39. Refer to the exhibit, which shows an error in system fortiguard configuration.

What is the reason you cannot set the protocol to udp in config system fortiguard?

Q40. Refer to the exhibit, which contains an active-active toad balancing scenario.

During the traffic flow the primary FortiGate forwards the SYN packet to the secondary FortiGate.
What is the destination MAC address or addresses when packets are forwarded from the primary FortiGate to the secondary FortiGate?

Q41. Refer to the exhibit, which shows a network diagram.

Which IPsec phase 2 configuration should you impalement so that only one remote site is connected at any time?

Q42. Refer to the exhibit, which shows config system central-management information.

Which setting must you configure for the web filtering feature to function?

Q43. Refer to the exhibit, which contains a partial OSPF configuration.

What can you conclude from this output?

Q44. Exhibit.

Refer to the exhibit, which provides information on BGP neighbors.
Which can you conclude from this command output?

Q45. Refer to the exhibit which shows an OSPF network.

Which types of link-state advertisements (LSA) will NGFW-1 send if it is a backup designated router (BDR)

Q46. Exhibit.

Refer to the exhibit, which contains the partial ADVPN configuration of a spoke.
Which two parameters must you configure on the corresponding single hub? (Choose two.)

Q47. Refer to the exhibit, which shows a network diagram.

Which protocol should you use to configure the FortiGate cluster?

Q48. Refer to the exhibit which shows information about an OSPF interface.

What two conclusions can you draw from this command output? (Choose two.)

Q49. Refer to the exhibit, which contains a partial BGP combination.

You want to configure a loopback as the OGP source.
Which two parameters must you set in the BGP configuration? (Choose two)

Q50. Refer to the exhibit, which shows a routing table.

What two options can you configure in OSPF to block the advertisement of the 10.1.10.0 prefix?
(Choose two.)

Q51. You want to have faster detection for OSPF.
Which parameter should you enable on both connected FortiGate devices?

Q52. Refer to the exhibit, which contains a partial OSPF configuration.

What can you conclude from this output?

Q53. Which statement about meta fields is true?