Q56. Which of these is a configurable VLAN on a CX switch?

Q57. A junior network engineer needs to configure a network interface with the IP address 10.1.1.1 and a subnet mask of 255.255.255.0.
Which of the following are valid ways to express this configuration on an HPE Aruba Networking CX switch? (Select all that apply.)

Q58. A Network Operator needs to explain to a new team member how a switch prevents the endless looping of broadcast frames in a physically redundant topology. What Layer 2 protocol is specifically designed to prevent these loops by logically blocking redundant paths?

Q59. How can you describe HPE Aruba Networking stacking technologies supported to a new customer focused on another vendor’s products?

Q60. A Support Technician is working with an Aruba CX 6400 Series chassis switch. The customer needs to add 10Gbps SFP+ connectivity to the switch.
What hardware component must be installed in the chassis to provide this physical port connectivity?

Q61. You have recently configured a LAG interface between two HPE Aruba Networking CX switches. You have noticed congestion on one of the links and very little traffic on the other.
Based on the following output, what should you configure to reduce the congestion?
switch# show lacp aggregates lag10
Aggregate-name : lag10
Aggregated-interfaces : 1/1/1 1/1/2
Heartbeat rate : Slow
Hash : l3-src-dst
Aggregate mode : passive

Q62. You are checking the interface details for an Access Point that cannot reach HPE Aruba Networking Central. After reviewing the following output, which statement is true?

Q63. Which AOS-CX switch series are chassis based? (Select two)

Q64. With HPE Aruba Networking CX switches, which key feature is a fundamental concept of Zero Trust Security and SASE frameworks?

Q65. While investigating a fault, you discovered that a LAG interface from an aggregation switch was connected to two different access switches.
How can you re-configure the LAG interface so it will only come up if connected to the same access switch?

Q66. A newly connected 500R series access point is not visible in HPE Aruba Networking Central. You have run the following commands to troubleshoot.

Based on the output, what could be the problem?

Q67. Drag and Drop Question
Match each example to the corresponding security concept.

Q68. What type of network is characterized by having only two peers on the link?

Q69. A customer requires a network upgrade to replace their existing access switches. The new solution must support 25G speeds to the aggregation layer, with a maximum physical space of 1U, and it must be a fixed switch solution.
Which HPE Aruba Networking CX switch model would you initially propose?

Q70. A Network Technician is troubleshooting a 1Gbps copper link between two switches. The link is intermittently flapping (going up and down). The technician replaces the patch cable, but the problem persists. The cable run through the wall is approximately 80 meters. Which of the following are potential Layer 1 causes for this intermittent issue? (Select all that apply.)

Q71. A technician installed a new HPE Aruba Networking 580EX Series access point, which is cabled back to an HPE Aruba Networking CX 6000 48G 4SFP switch. However, there are no lights on the access point.
What could cause this issue?

Q72. You are about to start the initial configuration of an HPE Aruba Networking CX 6200M switch.
How would you connect to the switch to configure the SVI static IP address?

Q73. A Solutions Architect is choosing between different switch families in the HPE Aruba Networking portfolio. The primary requirement for an upcoming deployment is support for Virtual Switching Framework (VSF) to stack up to 10 switches into a single logical device for simplified management at the campus aggregation layer.
Which switch series has this specific software and hardware capability?